ORBITA NEWS
- Home
- Orbita News
P8010 Fingerprint smart lock Manual Download
Instructions for use ：Dear users,thank you for using this smart lock.Please read the installation instructions carefully before installing and using this product,and follow the instructions while installing. Orbita shall not assume any responsibility for any product problems, hazards and losses directly or indirectly caused by failure to follow the instructions while installing the smart lock.
Features:
Features:
1. Unlocking methods: Fingerprint, card, mechanical key, and password (standard 4-in-1); Wi-Fi (optional).
2. Semiconductor fingerprint reader: semiconductor biometric recognition of less than 0.5 seconds.
3. Surface finish: electroplating.
4. Internal construction: The smart lock is composed of the electronic part and the clutch part, and is easy to disassemble.
5. Theft & Prank prevention function: The system generates an alarm and triggers the one-minute lockout after 5 straight wrong inputs (invalid card, wrong password or fingerprint).
5. Theft & Prank prevention function: The system generates an alarm and triggers the one-minute lockout after 5 straight wrong inputs (invalid card, wrong password or fingerprint).
6. Scramble PIN code: The password is composed of 6 digits or more, and fuzzy password input is supported. That is, you may add in random numbers before and after the correct password to unlock.
7. Emergency cylinder: C-class lock cylinder.
8. Low voltage alarm: When the battery voltage is lower than 4.8 V, it alarms each time upon unlocking. And you can still unlock for about 200 more times, and after that, you cannot unlock, so be sure to replace the battery before reaching the limit.
9. Networking will automatically turn off when the battery is below 5.0V.
10. Built-in anti-tamper alarm function.
11.Unlocking records can be checked.
12.Single unlocking is supported.
13.Combined unlocking: If it is enabled, you need two of the four unlocking methods to unlock.
14.You can enable or disable the voice prompt based on your needs.
u Operating Instructions
Ø Factory Defaults
The default administrator password is "123456". By default, any 6-digit password, card, and fingerprint can be used for unlocking. After the administrator is registered and logs in to the lock system successfully, the default password is automatically deleted. And only the registered administrator and users are allowed to unlock.
....
MORE PLEASE DOWN THE pdf Manual
....
MORE PLEASE DOWN THE pdf Manual
